Drop Lowering Kit 4 Rear Drop Hanger compatible for GMC C10 1973-87 2WD

Fitment:

• Compatible for Chevrolet C10/R10 1973 - 1987
• Compatible for GMC C15 /C1500 / C1500 Pickup 1973-1987
• Note: for 2WD and short box only

Specification:

• Placement on Vehicle: Left, Right, Rear
• Drop Length: 4in.
• Drive Model: 2WD Only
• Material: Steel
• Package Size: 36.5*19*15.5cm
• Package weight: 7kg
• Surface: Powder coating

Package Includes:

• 2x Rear Drop Shackles (1.5" / 2" Adjustable)
• 2x Rear 2" Drop Leaf Spring (Gunmetal Gray Steel)
• Necessary hardware included

Installation Tips:

How to Install a Leaf Spring Hanger?

• Replacing a leaf spring hanger is rather easy. The leaf spring hanger installation consists of a few simple steps.
• You should lift your truck with a jack and place it onto jack stands.
• Then you should remove the front leaf spring from the hanger.
• Grind off the rivets that are holding the hanger and then hammer them out.
• Bolt the leaf spring hanger kit into the frame where the previous rivet holes were.
• Bolt the leaf spring to the hanger. The tricky part of the installation will be taking the rivets off.

How to Install or Replace Leaf Spring Shackles?

• Using a floor jack, raise the rear differential of your vehicle off the ground, Use jack stands under the frame to support the vehicle
• Lower the jack so that the suspension "droops", this will take the weight of the vehicle off the shackle and allow for removal of the mounting bolts
• Remove the lower mounting bolt from the shackle and spring and then lower the axle so that the spring drops out of the shackle
• Remove the upper mounting bolt which attaches the shackle to the mount on the frame then remove the existing shackle
• Insert the new shackle and mounting bolt.
• Leave the bolt loose to allow alignment of the shackle with the spring
• Raise the rear axle and align the spring eye with the shackle. Slowly work the spring back into the shackle, raising the jack a little at a time until the holes in the shackle and the spring eye line up.
• Install the mounting bolts through the shackle and the spring. Make sure to tighten accordingly
• Jack up the car to remove the jack stands then lower the vehicle back down
• Make sure the bolts stay tightened with weight on them